DELL GX150 SOUND DRIVER

Set the jumper on the replacement system board so it is identical to the one on the existing board. If you are disconnecting a device from the computer or are removing a component from the system board, wait 15 to 30 seconds after disconnecting the computer from AC power before disconnecting the device or removing the component to avoid possible damage to the system board. Leave the release lever extended so that the socket is ready for the new microprocessor package. The default is Enabled-Silent. However, the sound didn’t, but I’ve installed my old SoundBlaster and now sound issu is a-ok. The small desktop chassis accommodates up to two bit PCI expansion cards.

Uploader: Nikobei
Date Added: 14 October 2016
File Size: 41.2 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 56160
Price: Free* [*Free Regsitration Required]

Check all connectors to be certain that they are properly cabled and firmly seated. Using an 8-inch, 2 Phillips-head screwdriver, remove the screw holding the control panel to the chassis and pull the panel up and away from the chassis. Disconnect the cooling fan power cable from the FAN1 connector on the system board. If there are no screws with the bracket in the small mini-tower chassis, contact Dell.

If you are replacing the microprocessor, do not reuse the old heat sink. You don’t know what are you missing Deell default is Enabled-Silent. In addition, take note of the following safety guideline when appropriate: Connect a power xell to the power input connector on the back of the drive, and connect one of the device connectors on the EIDE cable to the pin interface connector on the back of the hard drive.

Last Drivers  STAR TSP143 PRINTER DRIVER

Insert the AGP card into the connector on the system board.

DELL Dell Creative Sound Blaster Live – Sound card – 5.1

To replace a front-panel insert, follow the ” Removing Front-Panel Inserts ” procedures in reverse. Removing the Floppy Drive Data Cable.

The small mini-tower chassis has a tab on the riser board. I’ll give a try with those. Otherwise, use the EIDE interface cable provided in the drive kit.

Dell Creative Sound Blaster Live – Sound card – : PC Accessories | Dell

See ” Resetting the Chassis Intrusion Detector ” for instructions. Your microprocessor replacement kit should include a replacement microprocessor heat sink and one replacement securing clips.

Make sure that the card is securely fastened by the AGP card clip. Replace the battery only with the same or equivalent type recommended by the manufacturer.

Do not touch the components or contacts on a card. Video connector upper and audio connectors lower.

Dell OptiPlex GX150 (20GB, Intel Pentium III, 1GHz, 256MB) PC Desktop – GX150

Replace the padlock, if required. Check to see that no tools or extra parts including screws are left inside the computer’s chassis. Be careful when using a screwdriver to press on the VRM connector levers.

Last Drivers  EOBD 1260 DRIVER DOWNLOAD

To avoid possibly damaging the drive by Sounc, ground yourself by touching an unpainted metal surface on the back of the computer. Reinstall the hard-drive bracket in the chassis by gently sliding the bracket into place until you hear it securely click. Press inward on the two tabs on the sides of the floppy drive to disengage dfll drive from the chassis; slide the drive upward and remove it from the chassis. That’s the dell gx driver download page for windows xg150, it has all the drivers you need surely Slide the board toward the back of the chassis until it clicks into place.

About micksimmonds – Dell Community

For the small mini-tower replace the riser board. Microprocessor and Cooling Package.

Soune the computer cover. Disconnect the combination data cable from the interface IDE2 and floppy drive data connectors on the system board. Optical drive supports slimline devices. This view shows the optical drive data cable removed.